• For Flemish eye wire rope splicing.
• Designed for low temperature toughness.
• Resists cracking when swaged
       (equals or exceeds stainless steel sleeves).
• Special processed low carbon steel.
• "Cold Tuff " for better swageability.

• Can be stamped for identification after swaging without concern for fractures when following these directions.
  • Use round corner stamps to a maximum depth of 0.015 in. (1/64).  The area for stamping should be on the side of the sleeve in the plane of the sling eye, and no less than 0.250 in. (1/4) from either end of the sleeve.
• Standard Steel Sleeve terminations have efficiency ratings as follows based on the catalog strength of wire rope.

Before using any National Swing fitting with any other type lay, construction or grade of wire rope, it is recommended that the termination be destructive tested and documented to prove the adequacy of the assembly to be manufactured.

"Cross Section of
Swaged Sleeve"

• Allows the swaging process to be completed in just two passes. Resulting in a 50-75% reduction in the number of passes required with conventional swaging systems.
• Allows the dies to close completely with each pass, resulting in...

• An increase in overall swaging process efficiencies (the job can be performed quicker).
• A reduction in the complexity of swaging (the concern for excess flashing between dies has been eliminated.
• A reduction in raining time needed for operations (more user friendly).

• The finished sleeve has a "Hex" appearance that provides a QUIC-CHECK look to determine if the termination has been swaged and provides a flat surface that allows for ease of I.D. stamping on the finished sleeve.